Sticker Pack (x4 items)

  • Sale
  • Regular price $27.00
  • 9 available
Tax included. Shipping calculated at checkout.


SAVE $12.00!

These decals are durable and suitable for inside or outside use. They can be applied easily to any smooth surface and will remove clean.

Logo Sticker: 100mm x 100mm
Lowdown Sticker: 200mm x 158mm
Mini Bumper Sticker: 200mm x 30mm
Nugget Industries Vinyl Cut Sticker: 280mm x 83mm

How to apply your die cut stickers:

1. Clean surface and remove any dirt, oils before attaching decal.
3. Carefully peel the decal away from backing paper. Discard backing paper.
4. Place decal onto cleaned surface and squeegee the entire decal surface to allow proper adhesion. Start from the top of the decal design and evenly squeegee in a downward motion from left to right all the way to the bottom of the decal.

How to apply your vinyl cut sticker:

The top layer is called application tape; it allows you to transfer the decal to the surface you want to stick it to. The next layer is the decal itself. The bottom layer is the backing paper, the adhesive underside of the decal rests on this.

1. Clean surface and remove any dirt, oils before attaching decal. Place decal on a hard smooth surface (front side of decal facing up). DO NOT remove clear transfer tape yet.
2. Using a credit card, squeegee the entire decal surface. Apply medium pressure to the decal surface. DO NOT remove clear transfer tape.
3. Carefully peel off the bottom corner of the transfer tape and hold down the backing paper. IMPORTANT: Make sure the entire decal is attached to the transfer tape. If the decal is not attached to the transfer tape, gently push it back onto the backing paper and re squeegee with medium pressure before trying to lift again. Discard backing paper.
4. Place decal onto final surface and squeegee the entire decal surface to allow proper adhesion. Start from the top of the decal design and evenly squeegee in a downward motion from left to right all the way to the bottom of the decal.
5. Carefully peel back the transfer tape, pulling down at a 45 degree angle. The decal should adhere to the surface. If the decal adheres to the clear transfer tape replace the decal back on the surface and squeegee the edges of the decal again. Repeat if necessary.

TIP: To remove any air bubbles under the decals after you have applied the decal, use a sewing needle, puncture the bubble and gently push the air bubble towards the hole with your finger.